MQ-R 触摸屏挂在iic2 ,原理图

/device/config/chips/t113/configs/evb1_auto/board.dts 配置如下，不确定PB2 PB3这样配置对不对

&twi2 {
	clock-frequency = <400000>;
	pinctrl-0 = <&twi2_pins_a>;
	pinctrl-1 = <&twi2_pins_b>;
	pinctrl-names = "default", "sleep";
	/*twi_drv_used = <1>; */
	dmas = <&dma 45>, <&dma 45>;
	dma-names = "tx", "rx";
	status = "okay";

		ctp@14 {
		compatible = "allwinner,goodix";
		device_type = "ctp";
		reg = <0x14>;
		status = "okay";
		ctp_name = "gt9xxnew_ts";
		ctp_twi_id = <0x2>;
		ctp_twi_addr = <0x14>;
		ctp_screen_max_x = <0x320>;
		ctp_screen_max_y = <0x1E0>;
		ctp_revert_x_flag = <0x0>;
		ctp_revert_y_flag = <0x0>;
		ctp_exchange_x_y_flag = <0x0>;
		ctp_int_port = <&pio PB 3 GPIO_ACTIVE_HIGH>;
		ctp_wakeup = <&pio PB 2 GPIO_ACTIVE_HIGH>;
		};
};

[    5.020379] hub 2-0:1.0: USB hub found
[    5.024809] hub 2-0:1.0: 1 port detected
[    5.072298] get ctp_power is fail, -22
[    5.076654] get ctp_power_ldo_vol is fail, -22
[    5.081656] sunxi_ctp_startup: ctp_power_io is invalid.
[    5.087588] get ctp_gesture_wakeup fail, no gesture wakeup
[    5.093781] gt9xxnew_ts 2-0014: 2-0014 supply ctp not found, using dummy regulator
[    5.102580] wakeup gpio_request is failed
[    5.107079] startup:ctp_ops.input_sensor_init err.
[    5.112480] can not startup device!
[    5.116395] regulator-dummy: Underflow of regulator enable count
[    5.123165] regulator-dummy: Underflow of regulator enable count
[    5.130121] gt9xxnew_ts: probe of 2-0014 failed with error -1
[    5.147897] vin_csi 5801000.csi: Adding to iommu group 0
[    5.229924] sunxi-vin-core 5809000.vinc: Adding to iommu group 0
[    5.253641] sunxi-vin-core 5809200.vinc: Adding to iommu group 0
[    5.282072] [VIN_WARN]get csi isp clk fail
[    5.286750] [VIN_WARN]get csi isp src clk fail
[    5.291737] [VIN_WARN]get csi mipi clk fail
[    5.296453] [VIN_WARN]get csi mipi src clk fail
[    5.301570] [VIN_WARN]get csi isp clk fail
[    5.306197] [VIN_WARN]Get isp reset control fail

已找到报错的对应代码