但是重启过程中，出现以下日志提示，并卡住，使得板子变板砖。

Hit any key to stop autoboot:  0 
input addr exceed dram scope
data abort
pc : [<43f34168>]          lr : [<43f75cd1>]
reloc pc : [<42001168>]    lr : [<42042cd1>]
sp : 42acf9ac  ip : 00000003     fp : 00000004
r10: 43faba18  r9 : 42b12e68     r8 : ffffffe6
r7 : 42acfa4c  r6 : 00800040     r5 : 00800040  r4 : 00800040
r3 : 00010000  r2 : 0080003c     r1 : 32f777fc  r0 : 00800040
Flags: nzCv  IRQs on  FIQs off  Mode SVC_32
Code: f011dbd5 d08e0c03 0103f021 0f02f1bc (eb04f851) 

完整的升级日志：

Sat Mar 30 08:51:08 UTC 2024 start to prepare -->>> /mnt/extsd/misc-upgrade/w4.1.0.zip <<<--
Sat Mar 30 08:51:08 UTC 2024 unpack image start...
Sat Mar 30 08:51:08 UTC 2024 /mnt/extsd/misc-upgrade/w4.1.0.zip md5 check success!
Sat Mar 30 08:51:08 UTC 2024 unpack image finish...
Archive:  /mnt/extsd/misc-upgrade/w4.1.0.zip
  inflating: boot.img
  inflating: boot.img.md5
  inflating: boot_initramfs.img
  inflating: boot_initramfs.img.md5
  inflating: rootfs.img
  inflating: rootfs.img.md5
  inflating: usr.img
  inflating: usr.img.md5
Sat Mar 30 08:51:35 UTC 2024 start to prepare -->>> /mnt/UDISK/misc-upgrade/boot_initramfs.img <<<--
Sat Mar 30 08:51:35 UTC 2024 unpack image start...
Sat Mar 30 08:51:36 UTC 2024 /mnt/UDISK/misc-upgrade/boot_initramfs.img md5 check success!
Sat Mar 30 08:51:36 UTC 2024 unpack image finish...
Sat Mar 30 08:51:36 UTC 2024 start to prepare -->>> /mnt/UDISK/misc-upgrade/boot.img <<<--
Sat Mar 30 08:51:36 UTC 2024 unpack image start...
Sat Mar 30 08:51:36 UTC 2024 /mnt/UDISK/misc-upgrade/boot.img md5 check success!
Sat Mar 30 08:51:36 UTC 2024 unpack image finish...
Sat Mar 30 08:51:36 UTC 2024 start to prepare -->>> /mnt/UDISK/misc-upgrade/rootfs.img <<<--
Sat Mar 30 08:51:36 UTC 2024 unpack image start...
Sat Mar 30 08:51:37 UTC 2024 /mnt/UDISK/misc-upgrade/rootfs.img md5 check success!
Sat Mar 30 08:51:37 UTC 2024 unpack image finish...
Sat Mar 30 08:51:37 UTC 2024 start to prepare -->>> /mnt/UDISK/misc-upgrade/usr.img <<<--
Sat Mar 30 08:51:37 UTC 2024 unpack image start...
Sat Mar 30 08:51:37 UTC 2024 /mnt/UDISK/misc-upgrade/usr.img md5 check success!
Sat Mar 30 08:51:37 UTC 2024 unpack image finish...
Sat Mar 30 08:51:37 UTC 2024 start to upgrade
do_upgrade_image ......
Sat Mar 30 08:51:37 UTC 2024 set system flag : upgrade_pre
Sat Mar 30 08:51:37 UTC 2024 write_nor_partition /tmp/upgrade/boot_initramfs.img > extend
mtd3: 00600000 00010000 "extend"
11696+1 records in
11696+1 records out
Sat Mar 30 08:52:29 UTC 2024 set system flag : boot-recovery
[  563.298855] sunxi-mmc sdc0: sdc set ios:clk 0Hz bm PP pm OFF vdd 0 width 1 timing LEGACY(SDR12) dt B
[  563.310464] [alarmtimer] have no shutdown alarm! alarmtimer_shutdown 322
[  563.318452] [VIN_WARN]video3 device have been closed!
[  563.324223] [VIN_WARN]video2 device have been closed!
[  563.329900] [VIN_WARN]video1 device have been closed!
[  563.335592] [VIN_WARN]video0 device have been closed!
[  563.341500] reboot: Restarting system
[  563.345733] 
[  563.347398] Restarting Linux version 4.9.191 (wanglang@CodeWL) (gcc version 6.4.1 (OpenWrt/Linaro GCC 6.4-2017.11 2017-11) ) #429 PREEMPT Sat Mar 30 08:31:26 UTC 2024
[  563.347398] 
[10]HELLO! BOOT0 is starting!
[13]BOOT0 commit : 5841e68a26
[98][pmu]: bus read error
[100]set pll start
[102]periph0 has been enabled
[105]set pll end
[107]board init ok
[109]rtc[0] value = 0x80000001
[112]DRAM use internal ZQ!!
[114]ZQ value = 0x30
[117]chip id check OK
[119]POWER SETTING ERROR!
[121]DRAM BOOT DRIVE INFO: V0.16
[124]DRAM CLK = 528 MHz
[126]DRAM Type = 2 (2:DDR2,3:DDR3)
[130]DRAMC read ODT  off.
[132]DRAM ODT off.
[135]DRAM SIZE =64 M
[137]dram_tpr4:0x0
[143]DRAM simple test OK.
[146]rtc standby flag is 0x0, super standby flag is 0x0
[151]dram size =64
[154]audio:avcc calibration
[159]spi sample_mode:0 sample_delay:27
[163]spinor id is: c2 20 19, read cmd: 6c
[167]Succeed in reading toc file head.
[170]The size of toc is b8000.
[204]Entry_name        = optee
[207]Entry_name        = u-boot
[213]Entry_name        = dtb
[217]Jump to second Boot.
M/TC: OP-TEE version: 15ee1539b (gcc version 5.3.1 20160412 (Linaro GCC 5.3-2016.05)) #1 Tue Mar 29 06:48:41 UTC 2022 arm
E/TC:0 0 platform_standby_fdt_parse:133 no pmu node
E/TC:0 0 sunxi_twi_parse_from_dt:121 no pmu node


U-Boot 2018.07-g949e36b-dirty (Dec 25 2023 - 11:38:54 +0000) Allwinner Technology

[00.295]CPU:   Allwinner Family
[00.298]Model: sun8iw21
I2C:   [I2C-ERROR]:twi_send_clk_9pulse() 147 SDA is still Stuck Low, failed. 
ready
[00.358]DRAM:  64 MiB
[00.362]Relocation Offset is: 01f33000
[00.384]secure enable bit: 0
E/TC:0   tee_read_fdt:433 fine node /firmware/optee failed with FDT_ERR_NOTFOUND
[00.399]smc_tee_inform_fdt failed with: ffff0000
[I2C-ERROR]:twi_stop() 339 STOP can't sendout!
[00.408]pmu_axp2101_probe pmic_bus_read fail
[I2C-ERROR]:twi_stop() 339 STOP can't sendout!
[00.416]bmu_axp2101_probe pmic_bus_read fail
[00.420]CPU=900 MHz,PLL6=600 Mhz,AHB=200 Mhz, APB1=24Mhz  MBus=300Mhz
[00.426]gic: sec monitor mode
sunxi flash map init
SPI ALL:   ready
[00.434]line:724 init_clocks
[00.437]flash init start
[00.439]workmode = 0,storage type = 3
[00.445]spi sample_mode:0 sample_delay:27
[00.450]spi sunxi_slave->max_hz:100000000 
SF: Detected mx25l25635e( ) with page size 256 Bytes, erase size 64 KiB, total 32 MiB
[00.462]sunxi flash init ok
[00.464]drv_disp_init
[00.471]handle_num : 4 
partno erro : can't find partition bootloader
partno erro : can't find partition boot-resource
Get bootloader and boot-resource partition number fail!
[00.495]drv_disp_init finish
[00.498]Loading Environment from SUNXI_FLASH... OK
[00.509]boot_gui_init:start
partno erro : can't find partition Reserve0
[00.515]Get Reserve0 partition number fail!
[00.520]set disp.fb0_rot_used fail. using defval=0
[00.524]set disp.fb0_rot_degree fail. using defval=0
[00.531]boot_gui_init:finish
partno erro : can't find partition bootloader
partno erro : can't find partition boot-resource
[00.542]Get bootloader and boot-resource partition number fail!
root_partition is rootfs
set root to /dev/mtdblock2
[00.552]update part info
CACHE: Misaligned operation at range [42acfd18, 42ad0518]
CACHE: Misaligned operation at range [42acfd18, 42ad0518]
CACHE: Misaligned operation at range [42acfd18, 42ad0518]
42acfd18: 746f6f62 6365722d 7265766f 00000079    boot-recovery...
42acfd28: 00000000 00000000 00000000 00000000    ................
42acfd38: ffffffff ffffffff ffffffff ffffffff    ................
42acfd48: ffffffff ffffffff ffffffff ffffffff    ................
42acfd58: 61647075 705f6574 616b6361 ff006567    update_package..
42acfd68: ffffffff ffffffff ffffffff ffffffff    ................
42acfd78: ffffffff ffffffff ffffffff ffffffff    ................
42acfd88: ffffffff ffffffff ffffffff ffffffff    ................
42acfd98: ffffffff ffffffff ffffffff ffffffff    ................
42acfda8: ffffffff ffffffff ffffffff ffffffff    ................
42acfdb8: ffffffff ffffffff ffffffff ffffffff    ................
42acfdc8: ffffffff ffffffff ffffffff ffffffff    ................
42acfdd8: ffffffff ffffffff ffffffff ffffffff    ................
42acfde8: ffffffff ffffffff ffffffff ffffffff    ................
42acfdf8: ffffffff ffffffff ffffffff ffffffff    ................
42acfe08: ffffffff ffffffff ffffffff ffffffff    ................
42acfe18: ffffffff ffffffff ffffffff ffffffff    ................
42acfe28: ffffffff ffffffff ffffffff ffffffff    ................
42acfe38: ffffffff ffffffff ffffffff ffffffff    ................
42acfe48: ffffffff ffffffff ffffffff ffffffff    ................
[00.686]bootmode[3]:0x5c
[00.688]update bootcmd
[00.690]change working_fdt 0x42af2e68 to 0x42ad2e68
[00.702]## error: update_fdt_dram_para : FDT_ERR_NOTFOUND
partno erro : can't find partition bootloader
partno erro : can't find partition boot-resource
Get bootloader and boot-resource partition number fail!
partno erro : can't find partition bootloader
partno erro : can't find partition boot-resource
Get bootloader and boot-resource partition number fail!
partno erro : can't find partition bootloader
partno erro : can't find partition boot-resource
Get bootloader and boot-resource partition number fail!
[00.752]update dts
phy_mode=rmii, phy_interface=6
gmac: *** using ephy_clk ***
request pwm success, pwm11:pwm11:0x2000c00.
FDT ERROR:fdt_get_all_pin:get property handle pinctrl-0 error:FDT_ERR_INTERNAL
sunxi_pwm_pin_set_state, fdt_set_all_pin, ret=-1
eth0
Warning: eth0 (eth0) using random MAC address - 9e:3e:8d:b4:cf:83

Hit any key to stop autoboot:  0 
input addr exceed dram scope
data abort
pc : [<43f34168>]          lr : [<43f75cd1>]
reloc pc : [<42001168>]    lr : [<42042cd1>]
sp : 42acf9ac  ip : 00000003     fp : 00000004
r10: 43faba18  r9 : 42b12e68     r8 : ffffffe6
r7 : 42acfa4c  r6 : 00800040     r5 : 00800040  r4 : 00800040
r3 : 00010000  r2 : 0080003c     r1 : 32f777fc  r0 : 00800040
Flags: nzCv  IRQs on  FIQs off  Mode SVC_32
Code: f011dbd5 d08e0c03 0103f021 0f02f1bc (eb04f851)