[21]HELLO! BOOT0 is starting!
[23]BOOT0 commit :
[25]set pll start
[31]periph0 has been enabled
[34]set pll end
[36][pmu]: bus read error
[38]board init ok
[40]ZQ value = 0x2f
[42]get_pmu_exist() = -1
[44]ddr_efuse_type: 0xa
[47]trefi:7.8ms
[49][AUTO DEBUG] single rank and full DQ!
[53]ddr_efuse_type: 0xa
[55]trefi:7.8ms
[58][AUTO DEBUG] rank 0 row = 13
[61][AUTO DEBUG] rank 0 bank = 8
[64][AUTO DEBUG] rank 0 page size = 2 KB
[68]DRAM BOOT DRIVE INFO: V0.33
[71]DRAM CLK = 936 MHz
[73]DRAM Type = 3 (2:DDR2,3:DDR3)
[76]DRAMC read ODT off.
[78]DRAM ODT value: 0x42.
[81]ddr_efuse_type: 0xa
[84]DRAM SIZE =128 M
[86]dram_tpr4:0x0
[88]PLL_DDR_CTRL_REG:0xf8004d00
[91]DRAM_CLK_REG:0xc0000000
[93][TIMING DEBUG] MR2= 0x20
[101]DRAM simple test OK.
[103]rtc standby flag is 0x0, super standby flag is 0x0
[109]dram size =128
[111]card no is 0
[113]sdcard 0 line count 4
[115][mmc]: mmc driver ver 2021-05-21 14:47
[125][mmc]: Wrong media type 0x0
[128][mmc]: Try SD card 0
[131][mmc]: mmc 0 cmd 8 timeout, err 100
[135][mmc]: mmc 0 cmd 8 err 100
[138][mmc]: mmc 0 send if cond failed
[142][mmc]: mmc 0 cmd 55 timeout, err 100
[146][mmc]: mmc 0 cmd 55 err 100
[149][mmc]: mmc 0 send app cmd failed
[152][mmc]: Try MMC card 0
[160][mmc]: mmc 0 cmd 1 timeout, err 100
[163][mmc]: mmc 0 cmd 1 err 100
[166][mmc]: mmc 0 send op cond failed
[170][mmc]: mmc 0 Card did not respond to voltage select!
[175][mmc]: SD/MMC 0 init error!!!
[178][mmc]: mmc 0 register failed
[182]Loading boot-pkg fail(error=2)