以下是串口部分提示信息
[11:43:44.921]Rx:
[ 108.106618] random: crng init done
[11:43:49.571]Rx:
[280]HELLO! BOOT0 is starting!
[283]BOOT0 commit : 97444f5
[285]set pll start
[288]periph0 has been enabled
[291]set pll end
[293]board init ok
[295]rtc[3] value = 0xf6f65006
[298]the chip id is 0x3
[300]the chip id
[11:43:49.594]Rx:
is 0x3
[302]the chip id is 0x3
[305]the chip id is 0x3
[307]the chip id is 0x3
[309]chip id check OK
[312][AUTO DEBUG] two rank and full DQ!
[316][AUTO DEBUG] DDR3 try success
[320][AUTO DEBUG] single rank and full DQ!
[325][AUTO DEBUG] rank 0 row
[11:43:49.618]Rx:
= 14
[328][AUTO DEBUG] rank 0 bank = 8
[332][AUTO DEBUG] rank 0 page size = 2 KB
[336]DRAM BOOT DRIVE INFO: V0.171
[339]DRAM Type = 3 (2:DDR2,3:DDR3)
[342]DRAMC read ODT off.
[345]DRAM ODT off.
[348]DRAM CLK = 774
[11:43:49.641]Rx:
MHz
[350]DRAM SIZE =256 M
[355]DRAM simple test OK.
[358]dram size =256
[361]card no is 0
[362]sdcard 0 line count 4
[365][mmc]: mmc driver ver 2020-07-22 11:09
[11:43:49.666]Rx:
[375][mmc]: Wrong media type 0x0
[378][mmc]: Try SD card 0
[382][mmc]: mmc 0 cmd 8 timeout, err 100
[386][mmc]: mmc 0 cmd 8 err 100
[389][mmc]: mmc 0 send if cond failed
[394][mmc]: mmc 0 cmd 55 timeout, err 100
[11:43:49.689]Rx:
[398][mmc]: mmc 0 cmd 55 err 100
[401][mmc]: mmc 0 send app cmd failed
[405][mmc]: Try MMC card 0
[11:43:49.720]Rx:
[429][mmc]: RMCA OK!
[431][mmc]: force 25m
[433][mmc]: mmc 0 bias 0
[436][mmc]: MMC 5.1
[438][mmc]: HSSDR52/SDR25 4 bit
[442][mmc]: 25000000 Hz
[444][mmc]: 7456 MB
[446][mmc]: SD/MMC 0 init OK!!!
[11:43:49.835]Rx:
[544]Loading boot-pkg Succeed(index=0).
[548]Entry_name = u-boot
[554]Entry_name = monitor
[558]Entry_name = dtb
[561]tunning data addr:0x430003e
[11:43:49.856]Rx:
8
[565]Jump to second Boot.
NOTICE: BL3-1: v1.0(debug):3eba4b6
NOTICE: BL3-1: Built : 10:18:25, 2020-05-21
NOTICE: BL3-1 commit: 8
ERROR: Error initializing runtime service tspd_fast
NOTICE: BL3-1: Prepa