请教T113S3串口2（PD1和PD2）和LCD引脚冲突

[yelong98]

串口0-5都开启了，其他串口都正常，唯独串口2找不到设备，dmesg看到PD1被lcd0占用
[ 0.736249] sun8iw20-pinctrl 2000000.pinctrl: pin PD1 already requested by 5461000.lcd0; cannot claim for 2500800.uart
[ 0.756395] sun8iw20-pinctrl 2000000.pinctrl: could not request pin 97 (PD1) from group PD1 on device 2000000.pinctrl
[ 2.597491] sun8iw20-pinctrl 2000000.pinctrl: pin PD1 already requested by 5461000.lcd0; cannot claim for 2500800.uart
[ 2.617710] sun8iw20-pinctrl 2000000.pinctrl: could not request pin 97 (PD1) from group PD1 on device 2000000.pinctrl
在board.dts里面把&lcd0和&disp里面都添加了status = "disabled";并且把相关引脚引用都注释了，还是报错PD1被lcd0占用。
//pinctrl-0 = <&dsi4lane_pins_a>;
//pinctrl-1 = <&dsi4lane_pins_b>;
继续改，把uboot-board.dts里面的lcd0也给disabled还是报错PD1被lcd0占用，求教哪位老铁遇到过？指点一点线索，多谢多谢

[awwwwa]

@yelong98 mkernel 强制重新编译内核试试看

[yelong98]

@awwwwa 多谢指导，已经解决，整个clean以后重编就生效了，搞不懂之前咋回事，好在最后解决了