V851S 小容量 nor flash 32M使用 misc-upgrade 进行 ota升级，无法进入recovery系统升级
-
使用misc-upgrace按照小容量升级流程，写入extend分区后，会重启。
但是重启过程中，出现以下日志提示，并卡住，使得板子变板砖。
Hit any key to stop autoboot: 0 input addr exceed dram scope data abort pc : [<43f34168>] lr : [<43f75cd1>] reloc pc : [<42001168>] lr : [<42042cd1>] sp : 42acf9ac ip : 00000003 fp : 00000004 r10: 43faba18 r9 : 42b12e68 r8 : ffffffe6 r7 : 42acfa4c r6 : 00800040 r5 : 00800040 r4 : 00800040 r3 : 00010000 r2 : 0080003c r1 : 32f777fc r0 : 00800040 Flags: nzCv IRQs on FIQs off Mode SVC_32 Code: f011dbd5 d08e0c03 0103f021 0f02f1bc (eb04f851)完整的升级日志：
Sat Mar 30 08:51:08 UTC 2024 start to prepare -->>> /mnt/extsd/misc-upgrade/w4.1.0.zip <<<-- Sat Mar 30 08:51:08 UTC 2024 unpack image start... Sat Mar 30 08:51:08 UTC 2024 /mnt/extsd/misc-upgrade/w4.1.0.zip md5 check success! Sat Mar 30 08:51:08 UTC 2024 unpack image finish... Archive: /mnt/extsd/misc-upgrade/w4.1.0.zip inflating: boot.img inflating: boot.img.md5 inflating: boot_initramfs.img inflating: boot_initramfs.img.md5 inflating: rootfs.img inflating: rootfs.img.md5 inflating: usr.img inflating: usr.img.md5 Sat Mar 30 08:51:35 UTC 2024 start to prepare -->>> /mnt/UDISK/misc-upgrade/boot_initramfs.img <<<-- Sat Mar 30 08:51:35 UTC 2024 unpack image start... Sat Mar 30 08:51:36 UTC 2024 /mnt/UDISK/misc-upgrade/boot_initramfs.img md5 check success! Sat Mar 30 08:51:36 UTC 2024 unpack image finish... Sat Mar 30 08:51:36 UTC 2024 start to prepare -->>> /mnt/UDISK/misc-upgrade/boot.img <<<-- Sat Mar 30 08:51:36 UTC 2024 unpack image start... Sat Mar 30 08:51:36 UTC 2024 /mnt/UDISK/misc-upgrade/boot.img md5 check success! Sat Mar 30 08:51:36 UTC 2024 unpack image finish... Sat Mar 30 08:51:36 UTC 2024 start to prepare -->>> /mnt/UDISK/misc-upgrade/rootfs.img <<<-- Sat Mar 30 08:51:36 UTC 2024 unpack image start... Sat Mar 30 08:51:37 UTC 2024 /mnt/UDISK/misc-upgrade/rootfs.img md5 check success! Sat Mar 30 08:51:37 UTC 2024 unpack image finish... Sat Mar 30 08:51:37 UTC 2024 start to prepare -->>> /mnt/UDISK/misc-upgrade/usr.img <<<-- Sat Mar 30 08:51:37 UTC 2024 unpack image start... Sat Mar 30 08:51:37 UTC 2024 /mnt/UDISK/misc-upgrade/usr.img md5 check success! Sat Mar 30 08:51:37 UTC 2024 unpack image finish... Sat Mar 30 08:51:37 UTC 2024 start to upgrade do_upgrade_image ...... Sat Mar 30 08:51:37 UTC 2024 set system flag : upgrade_pre Sat Mar 30 08:51:37 UTC 2024 write_nor_partition /tmp/upgrade/boot_initramfs.img > extend mtd3: 00600000 00010000 "extend" 11696+1 records in 11696+1 records out Sat Mar 30 08:52:29 UTC 2024 set system flag : boot-recovery [ 563.298855] sunxi-mmc sdc0: sdc set ios:clk 0Hz bm PP pm OFF vdd 0 width 1 timing LEGACY(SDR12) dt B [ 563.310464] [alarmtimer] have no shutdown alarm! alarmtimer_shutdown 322 [ 563.318452] [VIN_WARN]video3 device have been closed! [ 563.324223] [VIN_WARN]video2 device have been closed! [ 563.329900] [VIN_WARN]video1 device have been closed! [ 563.335592] [VIN_WARN]video0 device have been closed! [ 563.341500] reboot: Restarting system [ 563.345733] [ 563.347398] Restarting Linux version 4.9.191 (wanglang@CodeWL) (gcc version 6.4.1 (OpenWrt/Linaro GCC 6.4-2017.11 2017-11) ) #429 PREEMPT Sat Mar 30 08:31:26 UTC 2024 [ 563.347398] [10]HELLO! BOOT0 is starting! [13]BOOT0 commit : 5841e68a26 [98][pmu]: bus read error [100]set pll start [102]periph0 has been enabled [105]set pll end [107]board init ok [109]rtc[0] value = 0x80000001 [112]DRAM use internal ZQ!! [114]ZQ value = 0x30 [117]chip id check OK [119]POWER SETTING ERROR! [121]DRAM BOOT DRIVE INFO: V0.16 [124]DRAM CLK = 528 MHz [126]DRAM Type = 2 (2:DDR2,3:DDR3) [130]DRAMC read ODT off. [132]DRAM ODT off. [135]DRAM SIZE =64 M [137]dram_tpr4:0x0 [143]DRAM simple test OK. [146]rtc standby flag is 0x0, super standby flag is 0x0 [151]dram size =64 [154]audio:avcc calibration [159]spi sample_mode:0 sample_delay:27 [163]spinor id is: c2 20 19, read cmd: 6c [167]Succeed in reading toc file head. [170]The size of toc is b8000. [204]Entry_name = optee [207]Entry_name = u-boot [213]Entry_name = dtb [217]Jump to second Boot. M/TC: OP-TEE version: 15ee1539b (gcc version 5.3.1 20160412 (Linaro GCC 5.3-2016.05)) #1 Tue Mar 29 06:48:41 UTC 2022 arm E/TC:0 0 platform_standby_fdt_parse:133 no pmu node E/TC:0 0 sunxi_twi_parse_from_dt:121 no pmu node U-Boot 2018.07-g949e36b-dirty (Dec 25 2023 - 11:38:54 +0000) Allwinner Technology [00.295]CPU: Allwinner Family [00.298]Model: sun8iw21 I2C: [I2C-ERROR]:twi_send_clk_9pulse() 147 SDA is still Stuck Low, failed. ready [00.358]DRAM: 64 MiB [00.362]Relocation Offset is: 01f33000 [00.384]secure enable bit: 0 E/TC:0 tee_read_fdt:433 fine node /firmware/optee failed with FDT_ERR_NOTFOUND [00.399]smc_tee_inform_fdt failed with: ffff0000 [I2C-ERROR]:twi_stop() 339 STOP can't sendout! [00.408]pmu_axp2101_probe pmic_bus_read fail [I2C-ERROR]:twi_stop() 339 STOP can't sendout! [00.416]bmu_axp2101_probe pmic_bus_read fail [00.420]CPU=900 MHz,PLL6=600 Mhz,AHB=200 Mhz, APB1=24Mhz MBus=300Mhz [00.426]gic: sec monitor mode sunxi flash map init SPI ALL: ready [00.434]line:724 init_clocks [00.437]flash init start [00.439]workmode = 0,storage type = 3 [00.445]spi sample_mode:0 sample_delay:27 [00.450]spi sunxi_slave->max_hz:100000000 SF: Detected mx25l25635e( ) with page size 256 Bytes, erase size 64 KiB, total 32 MiB [00.462]sunxi flash init ok [00.464]drv_disp_init [00.471]handle_num : 4 partno erro : can't find partition bootloader partno erro : can't find partition boot-resource Get bootloader and boot-resource partition number fail! [00.495]drv_disp_init finish [00.498]Loading Environment from SUNXI_FLASH... OK [00.509]boot_gui_init:start partno erro : can't find partition Reserve0 [00.515]Get Reserve0 partition number fail! [00.520]set disp.fb0_rot_used fail. using defval=0 [00.524]set disp.fb0_rot_degree fail. using defval=0 [00.531]boot_gui_init:finish partno erro : can't find partition bootloader partno erro : can't find partition boot-resource [00.542]Get bootloader and boot-resource partition number fail! root_partition is rootfs set root to /dev/mtdblock2 [00.552]update part info CACHE: Misaligned operation at range [42acfd18, 42ad0518] CACHE: Misaligned operation at range [42acfd18, 42ad0518] CACHE: Misaligned operation at range [42acfd18, 42ad0518] 42acfd18: 746f6f62 6365722d 7265766f 00000079 boot-recovery... 42acfd28: 00000000 00000000 00000000 00000000 ................ 42acfd38: ffffffff ffffffff ffffffff ffffffff ................ 42acfd48: ffffffff ffffffff ffffffff ffffffff ................ 42acfd58: 61647075 705f6574 616b6361 ff006567 update_package.. 42acfd68: ffffffff ffffffff ffffffff ffffffff ................ 42acfd78: ffffffff ffffffff ffffffff ffffffff ................ 42acfd88: ffffffff ffffffff ffffffff ffffffff ................ 42acfd98: ffffffff ffffffff ffffffff ffffffff ................ 42acfda8: ffffffff ffffffff ffffffff ffffffff ................ 42acfdb8: ffffffff ffffffff ffffffff ffffffff ................ 42acfdc8: ffffffff ffffffff ffffffff ffffffff ................ 42acfdd8: ffffffff ffffffff ffffffff ffffffff ................ 42acfde8: ffffffff ffffffff ffffffff ffffffff ................ 42acfdf8: ffffffff ffffffff ffffffff ffffffff ................ 42acfe08: ffffffff ffffffff ffffffff ffffffff ................ 42acfe18: ffffffff ffffffff ffffffff ffffffff ................ 42acfe28: ffffffff ffffffff ffffffff ffffffff ................ 42acfe38: ffffffff ffffffff ffffffff ffffffff ................ 42acfe48: ffffffff ffffffff ffffffff ffffffff ................ [00.686]bootmode[3]:0x5c [00.688]update bootcmd [00.690]change working_fdt 0x42af2e68 to 0x42ad2e68 [00.702]## error: update_fdt_dram_para : FDT_ERR_NOTFOUND partno erro : can't find partition bootloader partno erro : can't find partition boot-resource Get bootloader and boot-resource partition number fail! partno erro : can't find partition bootloader partno erro : can't find partition boot-resource Get bootloader and boot-resource partition number fail! partno erro : can't find partition bootloader partno erro : can't find partition boot-resource Get bootloader and boot-resource partition number fail! [00.752]update dts phy_mode=rmii, phy_interface=6 gmac: *** using ephy_clk *** request pwm success, pwm11:pwm11:0x2000c00. FDT ERROR:fdt_get_all_pin:get property handle pinctrl-0 error:FDT_ERR_INTERNAL sunxi_pwm_pin_set_state, fdt_set_all_pin, ret=-1 eth0 Warning: eth0 (eth0) using random MAC address - 9e:3e:8d:b4:cf:83 Hit any key to stop autoboot: 0 input addr exceed dram scope data abort pc : [<43f34168>] lr : [<43f75cd1>] reloc pc : [<42001168>] lr : [<42042cd1>] sp : 42acf9ac ip : 00000003 fp : 00000004 r10: 43faba18 r9 : 42b12e68 r8 : ffffffe6 r7 : 42acfa4c r6 : 00800040 r5 : 00800040 r4 : 00800040 r3 : 00010000 r2 : 0080003c r1 : 32f777fc r0 : 00800040 Flags: nzCv IRQs on FIQs off Mode SVC_32 Code: f011dbd5 d08e0c03 0103f021 0f02f1bc (eb04f851)
Copyright © 2024 深圳全志在线有限公司 粤ICP备2021084185号 粤公网安备44030502007680号