编译Tiny 4.0镜像给v851se启动卡死在DRAM

[lmmuyu]

[278][pmu]: bus read error
[280]set pll start
[282]periph0 has been enabled
[285]set pll end
[287]board init ok
[289]DRAM use internal ZQ!!
[292]ZQ value = 0x2e
[294]chip id check OK
[296]POWER SETTING ERROR!
[299]trefi:7.8ms
[301][AUTO DEBUG] single rank and full DQ!
[305]trefi:7.8ms
[307][AUTO DEBUG] rank 0 row = 13
[311][AUTO DEBUG] rank 0 bank = 4
[314][AUTO DEBUG] rank 0 page size = 2 KB
[318]DRAM BOOT DRIVE INFO: V0.16
[321]DRAM CLK = 528 MHz
[324]DRAM Type = 2 (2:DDR2,3:DDR3)
[327]DRAMC read ODT  off.
[330]DRAM ODT off.
[332]DRAM SIZE =64 M
[334]dram_tpr4:0x0
[341]DRAM simple test OK.
[343]rtc standby flag is 0x0, super standby flag is 0x0
[349]dram size =64
[351]audio:avcc calibration
[354]card no is 0
[355]sdcard 0 line count 4
[358][mmc]: mmc driver ver 2022-10-25 19:07
[367][mmc]: Wrong media type 0x0
[370][mmc]: ***Try SD card 0***
[391][mmc]: HSSDR52/SDR25 4 bit
[394][mmc]: 50000000 Hz
[396][mmc]: 30436 MB
[398][mmc]: ***SD/MMC 0 init OK!!!***
[485]Loading boot-pkg Succeed(index=0).
[489]Entry_name        = optee
[492]Entry_name        = u-boot
[501]Entry_name        = dtb
[504]mmc not para
[506]Jump to second Boot.
M/TC: OP-TEE version: 15ee1539b (gcc version 5.3.1 20160412 (Linaro GCC 5.3-2016.05)) #1 Tue Mar 29 06:48:41 UTC 2022 arm
E/TC:0 0 platform_standby_fdt_parse:133 no pmu node
E/TC:0 0 sunxi_twi_parse_from_dt:121 no pmu node


U-Boot 2018.07-gb807adc-dirty (May 27 2024 - 23:20:22 +0800) Allwinner Technology

[00.584]CPU:   Allwinner Family
[00.587]Model: sun8iw21
I2C:   [I2C-ERROR]:twi_send_clk_9pulse() 147 SDA is still Stuck Low, failed.
ready
[00.647]DRAM: