T113s4的boot0启动异常

[c18842780426]

[28]HELLO! lidf===BOOT0 is starting!
[32]BOOT0 commit : 41ad3d9-dirty
[35]set pll start
[41]periph0 has been enabled
[44]set pll end
[45][pmu]: bus read error
[48]board init ok
[50]enable_jtag
[51]ZQ value = 0x2f
[53]get_pmu_exist() = -1
[55]DRAM BOOT DRIVE INFO: V0.34
[58]DRAM CLK = 792 MHz
[61]DRAM Type = 3 (2:DDR2,3:DDR3)
[64]DRAMC read ODT  off.
[66]DRAM ODT value: 0x42.
[69]ddr_efuse_type: 0xa
[72]DRAM SIZE = 256 MB
[79]DRAM simple test OK.
[81]rtc standby flag is 0x0, super standby flag is 0x0
[86]dram size =256
[89]card no is 2
[90]sdcard 2 line count 4
[93][mmc]: mmc driver ver 2021-05-21 14:47
[102][mmc]: Wrong media type 0x0, but host sdc2, try mmc first
[108][mmc]: ***Try MMC card 2***
[131][mmc]: RMCA OK!
[133][mmc]: mmc 2 bias 0
[136][mmc]: MMC 5.1
[138][mmc]: HSSDR52/SDR25 4 bit
[141][mmc]: 50000000 Hz
[143][mmc]: 7396 MB
[145][mmc]: ***SD/MMC 2 init OK!!!***
[28]HELLO! lidf===BOOT0 is starting!
[32]BOOT0 commit : 41ad3d9-dirty
[35]set pll start
[41]periph0 has been enabled
[44]set pll end
[45][pmu]: bus read error
[48]board init ok
[50]enable_jtag
[51]ZQ value = 0x2f
[53]get_pmu_exist() = -1
[55]DRAM BOOT DRIVE INFO: V0.34
[58]DRAM CLK = 792 MHz
[61]DRAM Type = 3 (2:DDR2,3:DDR3)
[64]DRAMC read ODT  off.
[66]DRAM ODT value: 0x42.
[69]ddr_efuse_type: 0xa
[72]DRAM SIZE = 256 MB
[79]DRAM simple test OK.
[81]rtc standby flag is 0x0, super standby flag is 0x0
[86]dram size =256
[89]card no is 2
[90]sdcard 2 line count 4
[93][mmc]: mmc driver ver 2021-05-21 14:47
[102][mmc]: Wrong media type 0x0, but host sdc2, try mmc first
[108][mmc]: ***Try MMC card 2***
[131][mmc]: RMCA OK!
[132][mmc]: mmc 2 bias 0
[136][mmc]: MMC 5.1
[138][mmc]: HSSDR52/SDR25 4 bit
[141][mmc]: 50000000 Hz
[143][mmc]: 7396 MB
[145][mmc]: ***SD/MMC 2 init OK!!!****

[c18842780426]

就是一直在boot0这里循环，我看boot0初始化也没有错误，就是不加载uboot，有大佬知道怎么解决吗